I just bought a 1999 CBR F4600 and am learning to ride. I took the MSRP course, always wear gear, etc. I´ve been practicing in low traffic streets and parking lots off and on for a couple of weeks (I would go everyday but it´s been raining a lot here in Houston) but here´s my question. I am having trouble - probably a psychological barrier - getting smooth starts from a stop. I can let the clutch out slowly and start without using any throttle but these starts are a little slow in traffic and impossible on a hill. But I´m a little sketched out by giving throttle to start from a dead stop because I don´t want the bike to take off. I end up reving too high (only up to 3-4K rpms, I´m not redlining or anything) with the clutch still in. I think the problem is that I´m afraid to let the clutch out, and I end up throttling down too much because the timing is off. My question is: am I just being a puss? What happens if I rev up to 3-4K rps and let the clutch out? How much room for error do I have? (That is, how much gas can I give before dropping the clutch is risky, leading to a wheelie or the bike taking off like a rocket.) I know, I know. I´m a total wuss. Any advice, suggestions? (Other than "suck it up" or "get a scooter", that is.)
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
More 2000 Honda CBR 600 F4 information
Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.
Bikez also recommends that you check out the technical
data and the riders' rating for the 00 Honda CBR 600 F4.
You can also rate it yourself. Use our efficient motorcycle
classifieds to sell or
buy
this bike. Your motorbike gets a high quality presentation. Ads are free.