SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
81 Honda CB 750 C discussion forum:RE: few prob |
| RE: few prob |
| arbuckle said 2009-03-05 00:38 |
| Replace the choke cable and that will likely fix that problem. As far as the front break goes that gets a bit more complicated. My bike had an issue where the pressure in the lines wasn´t getting releaved as heat increased and the break would slowly close. The fix to that was to pull off the master cyl reservour (the plastic thing on top of the break handle). When you pump the break fluid should spray up out of a small hole, if it doesn´t there is a clog in that little lazered hole. You will see one big hole when you will see the pump move, and then what looks like a very small indent. Take a needle and push into the middle of that indent. As soon as you can pump the break and fluid sprays out you know you have it cleared. |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message|
|
More 1981 Honda CB 750 C informationOur discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.Bikez also recommends that you check out the technical data and the riders' rating for the 81 Honda CB 750 C. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free. |