RE: Ignition switch

83 Honda GL 650 discussion forum:


RE: Ignition switch

RE: Ignition switch 
Matt Albinger said 2013-04-20 10:39 
 
To get the ignition switch out you have to pull your fairing. That´s a lot easier than it sounds. Once you pull it off, take off the cover for the black connector case that is below the gauges, and is where the pig tail for the ignition switch ends. Then a 10mm socket from behind and on each side of the switch will drop it out from behind. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.  

 

More 1983 Honda GL 650 information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 83 Honda GL 650. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.