83 Honda CM 250 C discussion forum:

RE: What is the correct belt tension?

RE: What is the correct belt tension?

Mark H. said 2009-07-30 01:36

Alternate method--
Drive belt slack can be checked by hand by lightly pushing up on the lower half of the drive belt midway between the sprockets. Drive belt slack is approximately correct if the belt can be pushed up 15-20mm (0.6-1.0 inches). However, inspection with the drive belt tension gauge is recommended for accurate measurement of drive belt slack. Caution: Drive belt slack inspection should be checked when the belt is cold (before riding). rear axle nut torque 55-65 Nm or 40-47 ft/lbs

<<Previous Answer Discussion overview Report spam Next>>

Enter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

More 1983 Honda CM 250 C information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 83 Honda CM 250 C. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.

Title
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text
Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.

About Bikez.com.	Contact Bikez.com	Motorcycle catalogue
Our privacy policy	Do not sell my data	Motorcycle classifieds