RE: problems with gaskets

83 Honda CM 250 C discussion forum:


RE: problems with gaskets

RE: problems with gaskets 
V4 said 2006-10-22 22:54 
 
I have found the CM250C to be cold blooded, that is it often doesn´t like to start after sitting for even a few days. The solution I found was to open the needle valve (flat bladed screwdriver)on the float chamber and drain some fresh fuel from the tank down into the chamber while catching the expelled fuel from the rubber drain hose into a glass jar for the lawnmower. Bike then starts right up. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.  

 

More 1983 Honda CM 250 C information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 83 Honda CM 250 C. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.