RE: Carburetor help

80 Honda CM 400 T (reduced effect) discussion forum:


RE: Carburetor help

RE: Carburetor help 
sblg43 said 2008-05-18 22:37 
 
On my CM400C I have two carbs with a long tube at the bottom of each. In the spring, when I get the bike started for the first time, I have to turn a small screw at the bottom of the carb, (near the tube) and the gasoline drains out through the tubes. After a few moments, I turn the screws tight again and the gas stops. Could these tubes of yours be the same? If so, try to turn the small screws clockwise to close the valve. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.  

 

More 1980 Honda CM 400 T (reduced effect) information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 80 Honda CM 400 T (reduced effect). You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.