I need carb float height settings

96 Suzuki VS 1400 GLP Intruder discussion forum:


I need carb float height settings

I need carb float height settings 
Michael Williams said 2012-06-22 11:41 
 
If anyone has the float level measurements for the carbs on the 1996 VS 1400, and where to measure from and to.
Please send me that information.
I have measured fuel level using drain tube against carb body, but
it calls for 16 or 17mm from mark to level, and I have about 23or 24mm. But the Clymer´s manual says to look at table 1 for float
mesurements,and I cannot find a table 1. I think it is an error in my copy. Where can I find the info I need?
Thank You
Michael 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.  

 

More 1996 Suzuki VS 1400 GLP Intruder information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 96 Suzuki VS 1400 GLP Intruder. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.