SPECS · PICS · REVIEWS · RATING
SPECS · PICS · RATING
|
86 Kawasaki ZL 600 discussion forum:RE: 86 ZL600 ignition switch |
| RE: 86 ZL600 ignition switch |
| Guy said 2011-08-04 01:30 |
| I just tore the assembly apart last night. You might not need an entire switch . If your ignition turns to it´s four points through the key then you don´t need a new ignition assembly. If you dig into the head lamp housing, you´ll find that there is a wiring harness that goes to the base of the ignition assembly. With two small screws on either side, you can remove the electrical harness and replace it. All the key does is twist a position rod that´s rectangular. The rod goes all the way through the ignition housing and comes out the bottom and intersects with the electrical harness in position below. You don´t need new keys, or a new ignition housing. All you need is a new electrical ignition harness. |
| <<Previous Answer Discussion overview Report spam Next>> |
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
|
Enter a comment or answer to this message|
|
More 1986 Kawasaki ZL 600 informationOur discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.Bikez also recommends that you check out the technical data and the riders' rating for the 86 Kawasaki ZL 600. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free. |