RE: DT250 point ignition on DT400 ?

76 Yamaha DT 400 discussion forum:


RE: DT250 point ignition on DT400 ?

RE: DT250 point ignition on DT400 ? 
YAMAN said 2009-10-28 23:07 
 
yes i know i have to time it and will have that done. i will have the source and pulser ohm tested to see which one is bad but 99% of the time im told its the pulser that goes bad. and since its a sealed unit its unrepairable. i wish somebody knew how to repair a pulser coil that would be great.when i get them tested i will let you know. dont you think its weird that the bike would idle fine but when throttled it would run poorly like it was running on half a cylinder. when i first took the side cover off alot of rusty water ran out, i think that shorted out the stator. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.  

 

More 1976 Yamaha DT 400 information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 76 Yamaha DT 400. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.