1978 CB200 side stand

75 Honda CB 200 discussion forum:


1978 CB200 side stand

1978 CB200 side stand 
Alan Gidley said 2022-09-22 13:46 
 
Side stand gives extreme lean. Despite removing all slack in pivot bolt hole no improvement. I resorted to buying a used side stand, cutting it in half below the spring fixing lug, it is solid steel not hollow, drilling and taping 3/8 whit thread both at cut & then welding a steel sleeve to join the two halves giving the side stand an extra 1.5 inches in length. It still abuts up against the rubber pad on the silencer. This has greatly improved the lean angle when using the side stand. 
 
<<Previous          Answer          Discussion overview          Report spam          Next>>

Comments, questions and answersEnter a comment or answer to this message

You can post your question, answer or comment as a guest. Or enter your e-mail to join the forum and get notifcations of new messages.

 
Title 		 
Signature
Optional e-mail
Enter your e-mail to join the forum and get notification of answers and new messages. You can unsubscribe with a single click. Bikez does not display, sell or misuse e-mail addresses.
Message text

Describe technical issues in detail to get quality answers. You can offer or request second-hand parts and equipment as a privat person. Bikez reserves the right to remove any improper or commercial content.
Accept that we store and display the message.  

 

More 1975 Honda CB 200 information

Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.

Bikez also recommends that you check out the technical data and the riders' rating for the 75 Honda CB 200. You can also rate it yourself. Use our efficient motorcycle classifieds to sell or buy this bike. Your motorbike gets a high quality presentation. Ads are free.