Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: GPZ 900 hose routing for the carbs- no tank
Blair said 2010-03-29 22:36
When running your 900 without the tank you must plug off the small nipple/vaccum port to the 3rd carb. the small line that goes to that nipple is the primer for the pet cock. if that hose is not plugged it will not start you may have to prime the motor through that nipple. the other hose is a vent for the gas tank. you dont need to worry about that one. so use a lawnmower gas tank with a fuel line to carb plug the small nipple on the carb it should then start right up i have run mine like that many times. the bike runs better with all lines hooked up correctly to tank. so if it does run a little ruff its b/c u dont have the tank on