Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: Carburetor help
sblg43 said 2008-05-18 22:37
On my CM400C I have two carbs with a long tube at the bottom of each. In the spring, when I get the bike started for the first time, I have to turn a small screw at the bottom of the carb, (near the tube) and the gasoline drains out through the tubes. After a few moments, I turn the screws tight again and the gas stops. Could these tubes of yours be the same? If so, try to turn the small screws clockwise to close the valve.