Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: need assistance
mrbones said 2005-10-15 05:51
One thing that you might check before doing anything like buying a new carb or whatever is that you might have an intake manifold leak. That will cause the motor to pop. The factory seals on the intake are not a very good design. Go find you an tube out of a 20" bike tire and cut 2 pieces about an inch wide. Install these pieces over the stock gaskets where the intake joins the heads. (it is a procedure that will probably make you cuss too!) Wrap them up with a little electrical tape and then put the clamps back on. Let me know if this solves your problem.