Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: DT125R
Pepsi said 2004-04-03 23:57
Yes.. from the before 2001, the DT´s power valve was controlled by 3 wires.. 1 factor... 1 wire for in, out and Rev Meter .. upon reaching a desired amount of Revs the valve would open ,, and stay open.. the bike could litterally rev from then on until it blows up. From 2001 the servo has 5 wires; in, out, rev, in to cpu, out of cpu. The Valve opens as normal based on Revs.. but then the CPU montiors performance, mix, revs etc and adjusts the valve for best performance, and at high top end revs closes the valve slightly to ensure no damage to bike.
You can post your question, answer or comment as a guest. Or
enter your e-mail to join the forum and get notifcations of new messages.
More 1997 Yamaha DT 125 R information
Our discussion forums are intended for short messages. We also welcome more extensive motorcycle reviews.
Bikez also recommends that you check out the technical
data and the riders' rating for the 97 Yamaha DT 125 R.
You can also rate it yourself. Use our efficient motorcycle
classifieds to sell or
buy
this bike. Your motorbike gets a high quality presentation. Ads are free.