Report this message as spam or having improper contents
Thank you for reporting improper contents. Reported messages will normally be checked manually within 24 hours. To avoid misuse of this forum by programmed robots, we have to ask for the characters in the picture below.
RE: i have question´s about my 74 XLCH 1000cc ironhead
Sully said 2004-08-24 06:04
you might just need to wear it in a little bit due to the fact that you have new plates and spacers that will "take a set" after a little burn-in. worst case try taking one set of plates out or make sure they didnt put too many in. be aware though that you will want to make or buy a spring compressor cause otherwise it is a hell of a job getting the pressure plate back on one of the studs far enough to start one of the self locking nuts ( I do it by hand but not for fun). Try a different oil ( you will want to change it anyway since it is shared with the transmission and you dont want the clutch break-in crud fouling it up.