05 Honda CRF 450 X discussion forum: Gearing- Stalling CRF 450 X
Title
Gearing- Stalling CRF 450 X
Entered by
Captn Bill
Date
2005-11-04 02:03:00
Hi Cris, YOur right on! Are you at altitude, I find my at 300 feet MSL above sea level runs rich, Might drop the e clip a notch , but I must say ITs a difficult time,. Try removing tank,(that means seat too) remove entire shut off valve pull thru frame. you might get a chance to remove top of carb. to access carb float bowl. hum, I removed my sub-frame lossed air box adn alll fenders. and teh air box Stays with sub frame as its removed by 4 bolts. I am not expert , had to change starter. it woudl hang, what a difficult had to remove chain tensioner and try to reach with 8mm ground down 1/4 drive socket. ITs tight.
ME neither I an old thumper from 60´s adn I need to lose 50 lbs. so why worry over light bike stuff.
YOu might also consider, a 51 or 52 rear sproket , Look at Side winders. an Awesome spoket, either Iron man or tri-metal. REmember one tooth in front equal around three in rear, small front requires more HP and wear chain as its moving faster for same HP
We invite you to introduce yourself by a few sentences if you are new to
this discussion group. Enter your e-mail to join the forum and get notifcations on new messages. Or post your question,
answer or comment as a guest. We have just improved this discussion forum and expect the number of users to increase.
More 2005 Honda CRF 450 X information
Our discussion groups are intended for short messages. We also welcome more extensive motorcycle reviews.
Bikez also recommends that you check out the technical
data and the riders' rating for the 05 Honda CRF 450 X.
You can also rate it yourself. Use our efficient motorcycle
classifieds to sell or
buy
this bike. Your motorbike gets a high quality presentation. Ads are free.
Enter a comment or answer to this message